Snorkel MX19-sn1004-1599 Uživatelský manuál stáhnout pdf

MX15/19

NEVER operate the machine

within ten feet of power lines.

THIS MACHINE IS NOT INSU-

LATED.

NEVER elevate the platform or

drive the machine while el-

evated unless the machine is

on firm level surface.

NEVER sit, stand or climb on

guardrail or midrail.

NEVER operate the machine without first surveying the work area for surface hazards such as

holes, drop-offs, bumps and debris before operating machine.

NEVER operate the machine if all guardrails are not properly in place and secured with all

fasteners properly torqued.

SECURE chain across entrance after mounting platform.

NEVER use ladders or scaffolding on the platform.

NEVER attach overhanging loads or increase platform size.

LOOK up, down and around for overhead obstructions and electrical conductors.

DISTRIBUTE all loads evenly on the platform. See the back cover for maximum platform load.

NEVER use damaged equipment. (Contact UpRight for instructions. See toll free number on

back cover.)

NEVER change operating or safety systems.

INSPECT the machine thoroughly for cracked welds, loose hardware, hydraulic leaks, damaged

control cable, loose wire connections and wheel bolts.

NEVER climb down elevating assembly with the platform elevated.

NEVER perform service on machine while platform is elevated without blocking elevating assembly.

NEVER recharge batteries near sparks or open flame; batteries that are being charged emit

highly explosive hydrogen gas.

AFTER USE secure the work platform against unauthorized use by turning key switch off and

removing key.

NEVER replace any component or part with anything other than original UpRight replacement

parts without the manufacturers consent.

Safety Rules and Operating Instructions

WARNING

All personnel shall carefully read, understand and follow all safety rules,

operating instructions and the Scaffold Industry Association's MANUAL OF

RESPONSIBILITIES before performing maintenance on or operating any

UpRight aerial work platform.

Operator Manual

MX15/19

SERIAL NO. 1004 - Current

1 2 3 4 5 6 7 8

Shrnutí obsahu

Strany 1 - Operator Manual

1MX15/19NEVER operate the machinewithin ten feet of power lines.THIS MACHINE IS NOT INSU-LATED.NEVER elevate the platform ordrive the machine wh

Strany 2 - Inspection

2Figure 2: Controller12. Visually inspect the elevating assembly fordamage or erratic operation. Check for missing orloose parts.13. Partially lower t

Strany 3 - Operation

3OperationBefore operating work platform ensure that pre-operation and safety inspection has been completed,any deficiencies have been corrected and t

Strany 4 - Transporting Work Platform

4After Use Each Day1. Ensure that the platform is fully lowered.2. Park the machine on level ground, preferablyunder cover, secure against vandals, ch

Strany 5 - Maintenance

5MaintenanceNever perform service on the work platformin the Elevating Assembly area while theplatform is elevated without first blockingthe Elevating

Strany 6 - Battery Charging

6Battery MaintenanceHazard of explosive gas mixture. Keepsparks, flame and smoking materials awayfrom batteries.Always wear safety glasses when workin

Strany 7

7MX-SERIES LABEL INSTALLATION: THESE LABELS SHALL BE PRESENT AND IN GOODCONDITION BEFORE OPERATING THE WORK PLATFORM. BE SURE TO READ, UNDER-STAND AND

Strany 8 - FOR MORE INFORMATION

8ITEMPlatform SizeStandard w/DeckOptional w/o DeckMaximum Platform CapacityStandard w/DeckOptional w/o DeckMaximum Number of OccupantsStandard w/DeckO